I'm trying to install a san client. But from NBU admin console, on SAN Client section I can't see any fiber transport device found.
I followed Netbackup San Client Installation and Configurarion Guide. Both installation (FT media server and san client ran ok without errors)
Some informations:
-FT Media Server is a Linux RHEL6.3 64bits running NBU 7.5.0.4
-San Client is a RHEL6.2 64 bits running NBU Client 7.5.0.4
-Checked san client licence on master server.
-SAN zoning configured properly
-FT Media Server HBA Qlogic ok
-From san client set 'bpclntcmd -sanclient 1
-From NBU administration console
-From san client operating system I can see two device "ARCHIVE Model: Python" (cat /proc/scsi/scsi). So physically it sees device from ft pipe.
-Sending screenshots from NBU Administration Console.
Need help.